This kit allows you to control a lamp or group of lamps through a DMX signal. The DMX protocol was developed by USITT in 1986 with the purpose of controlling dimmers, scanners, moving heads and other lighting devices with simple wiring. It is mainly being used in theatres and discos, but you can use it in any place where a central or automated lighting is needed.
Use our "USB controlled DMX interface" K8062: USB CONTROLLED DMX INTERFACE (kit version), VM116: USB CONTROLLED DMX INTERFACE (built version) or any other control console compliant with the DMX-512 protocol as a controller
suitable for resistive loads like incandescent lamps and mains voltage halogen lighting
system addressability: 512 unique addresses, selectable with DIP switch
status LED for power and error detection
toroidal filtering for low
noise (according to EN55015)
stand alone "test" mode
control source: DMX-512, 3 pin XLR socket included
load capacity: max. 1000 W @ 230V (5A) or 500W @ 115V
power Input: 115/230 VAC