Four-channel wireless relay with remote control that operates at 433MHz. The switching mode is set by the switch on the relay board. the button is kept pressed (jumper in position M). The scope covers several walls from 15 m to 50 m in the open air
The relay has a changeover contact to switch the load up to the current 10A. Delivered in a plastic box
Not produced is delivered as standard. To register the controller with the relay unit, please include it in the note
Driver registration instructions: When the power is turned on, press the K1 key to turn on the red LED. Press any button on the remote control, when the LED is off, the controller is registered
Instructions:
1. Press the learning code, the indicator flashes, loosen your finger, press any button on the remote control, the indicator flashes 2 times and turns off, it means it learned it successfully
2. You can learn more than 12 PCS 2262 or 1527 with the different code wireless remote control
3. delete / clean: press the learn button a few 8 seconds, the indicator turns on and off, it means that the information it keeps has been deleted successfully
4. Each receiver is individually controlled and will not affect each other (if you need to use multiple receivers)
Output form work:
1. Self-locking: connect JP1 with jumper cap
2. Jog: jumper cap is not engaged, JP1 and JP2 are not connected either
3. Interlock: connect Jp2 with bridge cap, Jog: press a button is ON, loosen your finger on the m same button is OFF (needs channel switch and button remote control)
Self-lock: pressing a button for once is ON, pressing the same button again is OFF (needs channel switch and button remote control )
Interlock: press one button to turn ON, press another button to turn OFF (need a channel switch and 2 remote control buttons).
RF relay, 4 channels
Working voltage: 11V ~ 14V DC
Working band: 433 MHz
Smart consumption: 10 mA
Max. consumption: 200mA (4 relays)
Range: 15 ~ 50m
Relay contacts: 1x change
Contact load relay: 30V / 10A DC, 250V / 10A AC, applies to resistive load
Controller: 4 buttons (A, B, C, D)
Controller batteries: CR2032
Weight: 22g
Board dimensions: 65 x 50 x 20mm